CAC / BDP 40GVM Specifications download pdf (Page 12)

CLEANING AND MAINTENANCE

ELECTRICAL SHOCK HAZARD

Failure to follow this warning could result in personal injury

or death.

Disconnect all power to unit to avoid possible electrical

shock during cleaning or maintenance. Set unit power

switch to OFF position.

WARNING

At the beginning of each season clean the detection unit.

1. Disconnect tubing and low voltage power cord from the

detection unit and slide unit out of mounting bracket

2. Remove the top of the detection unit and take out the float.

3. Clean the detection unit and the float using a solution of

water containing 5% bleach.

4. Replace the float in its original position with the magnet

side facing up.

5. Snap cover back into place.

6. Perform an operational test (see item 13 under installation

section).

Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.

C a t a l o g N o : I I K --- 5 3 D S 9 0 0 --- C P --- 0 5

R e p l a c e s : I I K --- 5 3 D S 9 0 0 --- C P --- 0 4

Edition Date: 03/13

1 2 ... 7 8 9 10 11 12

No comments

CAC / BDP 40GVM Specifications Page 12